Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Newbie with zenith
#1
Hi guys,

New to the forum but been reading a lot of the threads, some great help out there. Just about to fit some zenith 12.5mm worktops, new to me. Any advice on best cutters to use.

Cheers.
[-] The following 1 user Likes Davie C's post:
  • Joe the chip (03-06-2018 04:20 PM)

Reply
#2
Have just researched this. Use a sharp triple chip, no need for a diamond blade. I'm fitting one next week.

Reply
#3
Even though it's thin I still do 2-3 passes, it's that hard.  Look at the you tube vids, they are a good help.  I did a Wickes zenith this  week the glue was a rapid setting which is to quick and thick.    .

Reply
#4
cheers, i don't have suction clamps, maybe if i get some more i can justify the cost. what are you guys using to clamp the tops.

Reply
#5
Most of the time i wedge them in from the opposite wall, or use my gecko's if its an open end.

Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)